Skip to content

Guide to Pause Buffered Short Boost for Early Screw

Pause Buffering

Buffering for Run

More

Share

Explore

Buffering for Run

Now we begin looking for the frame to start running. With the stick neutral you’re going to advance several frames while watching for some information between pauses.

First you’ll be verifying that your flash cancel has left you in the correct position

⁠

⁠

Screen Shot 2022-11-06 at 9.31.22 AM.png

⁠

⁠

Its very important that you check for this position during the frame advances. If you have not settled into this position, something has gone wrong and you should abort the attempt and restart.

⁠

Once you have confirmed your position, focus on this section to start looking for your cue to start running:

⁠

Screen Shot 2022-11-06 at 9.57.02 AM.png

⁠

⁠

Specifically, we’re watching for these flash particles to emerge from the doorway.

⁠

Screen Shot 2022-11-06 at 10.01.15 AM.png

⁠

⁠

⁠

Here it is frame by frame:

⁠

⁠

Screen Shot 2022-11-06 at 1.01.36 PM.png

⁠

⁠

⁠

⁠

Screen Shot 2022-11-06 at 1.02.34 PM.png

⁠

⁠

⁠

⁠

Screen Shot 2022-11-06 at 1.03.09 PM.png

⁠

⁠

⁠

⁠

Screen Shot 2022-11-06 at 1.04.12 PM.png

⁠

⁠

This sliver emerging is what we’ve been looking for. This isn’t the frame but we’re close.

⁠

⁠

Screen Shot 2022-11-06 at 1.06.33 PM.png

⁠

⁠

There’s two frames of the sliver, neither is what we want.

⁠

⁠

Screen Shot 2022-11-06 at 1.07.26 PM.png

⁠

⁠

This is the target! There’s two frames that look something like this and they both work

⁠

⁠

Screen Shot 2022-11-06 at 1.09.27 PM.png

⁠

⁠

2nd valid frame

⁠

⁠

Screen Shot 2022-11-06 at 1.10.11 PM.png

⁠

⁠

Too late

⁠

Once again I’ll note that +/- frame advances are a great choice here, as well as advancing two frames at a time.

Once you have found the frame, hold left, unpause, and immediately start mashing booster.

⁠

Screen Shot 2022-11-06 at 1.33.44 PM.png

⁠

⁠

If all goes well, you’ll slide to the right edge with an uninterrupted run.

⁠

Next:

Store⁠

⁠

Want to print your doc?
This is not the way.

Try clicking the ⋯ next to your doc name or using a keyboard shortcut (

CtrlP

) instead.