Skip to content
In progress
Add supports to centre backrests
Seating
Research
Improve CAD for bedroom
Bedroom
Design
Find cheaper threaded inserts
Research
Confirm which side the hinges should be on the door
Box
Research
Rename storage / kitchen
Interior
Research
No results from filter
To do
Check that large fridge can fit through the door / be removed after the interior is complete
Storage port
Research
Look into Onshape “routing curves”
Design
Inset Joiner on bed base is misaligned
Bedroom
Design
Investigate new latch
Research
Check what work needs to be done on the chassis
Chassis
Research
Think more about the ceiling, and how this will be finished
Ceiling panels
Research
Remember we shortened the bathroom space by at least 100mm… Do we have to lengthen the body?
Toilet
Design
Add clearance for adhesive to solar CAD
Solar
Design
Add better products for solar panel mounts to Coda
Solar
Research
Check two Multi RS Solar’s can exist on the same DC circuit without interference
Electrics
Research
Think about extractor fan for kitchen if we change to portable cooktops
Kitchen stbd
Research
Decide on product range and technology for grey water pipes, fittings, valves etc. Add to CAD and Notion.
Waste
Research
Add trim / spacers to Onshape window CAD
Windows
Design
Add storage for portable induction hotplates to CAD, remove built-in hob
Kitchen stbd
Design
Add estimate for window armour plate storage shelf
Storage port
Research
Research how to power a PWM fan with an Atom PWM unit
Interior
Research
Add L-Track to side of box
Box
Design
Design slides, locks, seals for cab bars storage
Cab bars storage
Design
Add water pipes to conduits
Conduits
Design
Decide on battery removal tape
Batteries
Research
Work through pipe sizing calculations
Water
Research
Remember pressure relief valve on holding tank
Heating
Research
Add mains pressure connection that bypasses the tanks / pump?
Water
Design
Remember pressure reducer valve on water fill inlet
Water
Research
Design overflow into shower tray (with exit pipe through floor)
Shower tray
Design
Add chargers to CAD model (seating)
Seating
Design
Work out if this needs to be waterproof - shower seals etc.
Bathroom base
Research
Design bathroom shower door
Shower wall
Design
Design toilet door
Toilet wall
Design
Where does the rear camera go?
Garage
Research
Design bathroom lighting
Bathroom lighting
Design
Research fresh water plumbing
Water
Research
Can we completely remove the inner cappings? They will just get in the way of furniture that needs to go right up to the wall...
Box inner cappings
Research
Narrow down estimates for alternator wiring
Alternator wiring
Research
Change crawl-through door so it’s hinged on the RHS (so we have access to the shower door latch if the shower door is latched open).
Crawl through (box)
Research
Update CAD to use 18mm ply for furniture frames
Design
Add glue and fixation hardware to furniture frame estimate
Research
Add glue and fixation hardware to furniture front estimate
Research
No results from filter
Want to print your doc?
This is not the way.
This is not the way.
Try clicking the ··· in the right corner or using a keyboard shortcut (
CtrlP
) instead.