If you only have a single Sentry to pair to a property, you can use the +Add device option on the Devices page.
To begin pairing, do the following:
Press + Add device under the property you wish to add a Sentry to.
When adding a new device, make sure you press + Add device under the property you wish to add that device to.
For example, in the image below if I wanted to add a device to Tim’s House, I would select the + Add device button in that box.
Skip through the prompts by pressing Next until you get to the Wi-Fi network selection screen.
If you are already connected to the network you wish to connect to, enter the Wi-Fi password and select Next.
If you are not connected to the Wi-Fi network you wish to connect to, press Use other network.
This will open up your phone’s system settings. Select and connect to the network you wish to connect your Sentry to.
Once connected, press the back button on your phone to go back into the Sentry app. Now enter your password and select Next.
The app will begin searching for your Wynd Sentry. Once the device has been discovered, a prompt will appear stating that a Sentry has been found. Select Connect to begin the pairing process.
The app will begin to automatically configure your Sentry device. This may take several minutes.
If the pairing was successful, you will be met with a room assignment screen. Select the room type that the Sentry will be placed in and give it a name. Once finished, press Add device.
If you do not have any other devices to pair, you can end the session. You will be met with a success screen.
Your Sentry has now been paired to your property. Your device will now show up on the Devices page. If you do not see your device appear, give it a minute and then refresh the page by pulling down on the screen. You can also refresh the app by closing and reopening it.
Want to print your doc? This is not the way.
Try clicking the ⋯ next to your doc name or using a keyboard shortcut (
