Skip to content
Glue plywood pieces on inside of fuselage where the carbon spars go throughGlue on servo mount for parachute bayGlue on clear plastic hatch adaptorsGlue on wing adaptersInstall carbon tubes into inside of fuselageGlue fuselage halves togetherGlue in tray mounting piecesGlue on landing cushions Glue servo bays into wingsInstall locking hooksGlue on the adapters onto the tail finsGlue on tail fin adapters onto fuselageGlue wings togetherGlue on screw bases for nacelle coversGlue lock mounts into foamGlue in motor mounts (be careful as not to shift the foam as this needs to be as accurate as possible)Glue in the battery plateInstall tail servos (Install them towards the front of the fuselage)Install aileron servos Install cover on aileron servosInstall circular servo discAssemble push rods and installInstall control horns on all control surfacesInstall motorsInstall power connectorsInstall motor cover
Lab 12 - Believer Assembly
Build Instructions
Each subassembly section should be followed in order
Frame Assembly
Take the time to test fit the wings and tail, ensuring that they do not wobble.
Servos, tail, and motor assembly:
Electronics
Want to print your doc?
This is not the way.
This is not the way.
Try clicking the ··· in the right corner or using a keyboard shortcut (
CtrlP
) instead.