Skip to content
Lab 7
In this lab my groups team worked on controller 2. Controller 2 was a hardware change. We were asked to take some knobs and switches off and make the controller less clustered with switches. When all the unneeded switches and knobs were removed from the shell, they were hot glued to the inside of the shell out of the way to cause no problems. The other team in my group worked on controller 5’s software and updated it to work with the believer drone.
For the software portion of the lab, we had to modify and select the correct software for the DATX controller.
Step 1: Connect the DATX controller to a laptop with the downloaded software.
Step 2: Go to and then select the software that we wanted to install onto the controller.
Step 3: Select the controller from the connected device list.
Final step: Start the upload to the controller
Want to print your doc?
This is not the way.
This is not the way.
Try clicking the ⋯ next to your doc name or using a keyboard shortcut (
CtrlP
) instead.