Quick Start Guide

Step 1 - Connecting Power

⁠

You are able to connect your Threm 400 to power via: The optional 24v power supply, or you can connect the Therm 400 with the included male to male cable to the Brick 1.0.

Step 2 - Setting the Temperature

⁠

Please Note: If the set temperature changes too drastically the soldering iron will begin to cool down and will show a error message. If this occurs you will need to disconnect and reconnect power to the soldering iron.

To begin press the "U/I" Button Located on the front

of the unit. The voltage display will begin to flash, to

adjust turn the adjustment knob up or down accordingly. Pressing the adjustment knob will change the digit you are adjusting. Next to adjust the current press the "U/I" Button again and repeat the stated.

How to Solder Recommend Videos:

⁠

https://www.youtube.com/watch?v=Qps9woUGkvI⁠

⁠

https://www.youtube.com/watch?v=oqV2xU1fee8⁠

⁠

We hope our suggestions help!

Gallery

Want to print your doc?
This is not the way.

Try clicking the ··· in the right corner or using a keyboard shortcut (

CtrlP

) instead.