Skip to content
Porta PWR Guides Page
  • Pages
    • Home
      • Brick 1.0 Owners Manuel
        • icon picker
          Quick Start Guide
        • Features
        • Advanced Settings
      • Therm 400 Owners Manuel
        • Quick Start Guide
        • Features
        • Advanced Settings
      • Contact Us
      • PDF Download
Porta PWR Guides Page
/
/
Quick Start Guide
Share
Explore

Quick Start Guide

Step 1 - Connect your Power Source
⁠
You can connect your power source via:
XT60
USB C PD
DC Barrel Jack
Screw Terminal
Input Voltage should be between 12-24volts @ 100
Step 2 - Adjusting Output
⁠
Always ensure that the output of the power supply is off, to protect the power supply and the connected device. You can do this by pressing the adjustment knob. To begin press the "U/I" Button Located on the front of the unit. The voltage display will begin to flash, to adjust turn the adjustment knob up or down accordingly. Pressing the adjustment knob will change the digit you are adjusting. Next to adjust the current press the "U/I" Button again and repeat the stated.
Step 3 - Connecting Output
⁠
On the front of the unit there are two banana jacks. You are able to connect the included power leads or other banana jack connectors to these connectors. It is important that you check all polarities before powering up a device!
RED = POSITVE BLACK = NEGITIVE



Gallery
 
Want to print your doc?
This is not the way.
Try clicking the ··· in the right corner or using a keyboard shortcut (
CtrlP
) instead.