Explore

Lab 10 - Motors and Controls

In this lab, we continued to add and sync more instruments and parameters into our believer.

We have to make sure our believer is able to be connected to. For that, we needed a transmitter and receiver. We acquired a TBS Tracer Starter Set and began to identify which was which and soldered them to the appropriate parts.

We then had to pair the TX ad RX. We had a zip file to download and insert into the DATX in order to properly set this up. We were able to successfully bind the two together.

Next we we had to alter our FCU and paraemters becasue they did not align. SO, we uploaded a new file in order for them to work together. We then proceeded to test System connectivity and connected all sensors to the flight controller. We had all systems in the green as well.

Unfortunately, when we tried modifying the parameters tht prevented the GPS from working, even through troubleshooting, the system would never load and download/change the parameters. So we were unsuccessful in doing that.

Want to print your doc?
This is not the way.

Try clicking the ··· in the right corner or using a keyboard shortcut (

CtrlP

) instead.